STEP BY STEP DIRECTIONS FOR INSTALLING YOUR GARAGESCAPE

STEP 1 -REMOVE OLD DOOR INSULATION IF ANY IS ALREADY IN PLACE ON YOUR GARAGE DOOR

Removal of old door insulation is easy, simply slide the panel over into the hidden pocket and put your fingers behind panel, slightly bend panel outward and it will fall right out

STEP 2 - INSTALLATION OF GARAGESCAPE™ PANELS

The new GarageScape™ panels will go into your door the same way you removed the old ones but in reverse. Put edge of panel near side that has the hidden pocket, slightly bend panel in the middle until it fits into the door. Use installation tool or a piece of cardboard to pretect the panel from the edges chipping when installing. As you found out when you removed the old panels, if you are too rough, you can break the panel or at a minimum break off small pieces.

CLEANING NEW DOOR

Cleaning your GarageScape™ is simple and straightforward. All you need is a soft cloth, some gentle soap, and water. To remove debris and dirt from installation, use a soft brush to gently scrub the surface, then rinse with water. To keep your mural looking its best, we recommend using Windex or a mild glass cleaner to gently wipe off any dirt or stains.

INSTALLATION VIDEOS

GarageScape™ INSTALLATION VIDEO

DoorScape™ INSTALLATION VIDEO

RollScape™ INSTALLATION VIDEO

432441773_1187406239084618_5372200010880771032_n_edited.jpg

DIY GarageScape™ INSTALLATION INSTRUCTIONS

DoorScape™ and RollScape™ INSTALLATION INSTRUCTIONS

Congratulations on the purchase of your mural. Along with the vinyl mural you should also find a complete installation kit in the box with everything you need to install your DoorScape™/RollScape™

INCLUDED IN KIT

1ea Roll Blue Tape

8ea Rubber Coated Magnets

1ea Spray Bottle

1ea Micro-Fiber Towel

Before beginning installation of you DoorScape™, please wash your Garage door and remove any debris. Make sure the surface is clean and dry before proceeding. If you do not properly clean your door, it could lead to adhesion issues with your DoorScape™ mural.

Step 1 – Unroll your vinyl and put them in the proper order and orientation if they are not already marked for you.

Step 2 – Close garage door and clean inside of door. Pull the release handle to disengage the door while the wrap is being applied as may need to remove hinges depending on the type of door you have.

Step 3 – Remove hinges between top panel and second panel from top and clean area. (If installing DoorScape only) On RollScape™ remove pretection strips if present from each end of roll-up door.

Step 4 – Put top piece of your DoorScape™ in proper orientation onto door with backing in place using provided magnets to hold the panel in place.

Step 5 - Starting at the top...

SITE STILL BEING BUILT, Please come back later for more updates

CLICK HERE FOR LINK TO INSTALLATION VIDEO